Usually, I can figure it out and get a decent fit on the last try.
I ended up with a mediocre fit on the sides of all four fairings.
While the glue is drying,
Try to get a straight line down the sides of the fairings. The sides will want to round out.
I used my sharpened dowel to press and form a straight line. You can only do this while the glue is still wet.
The gap at the root edge was filled with some CWF pushed in with a single edge razor blade.
Light 400 grit sanding followed.
This was shot with filler/primer. The filler/primer showed the raised fibers in the sanded cardstock. More light sanding removed the raised fibers.
After all the filling and sanding,
Some CA glue was wiped on the inside edge and top to stiffen up the fairings.
No comments:
Post a Comment