A test sheet was printed on 20 lb. copy paper to check the fin decal sizes.
These are a tight fit with an even border around the custom drawn letters.
The fit seemed good and the water slide decals were printed.
Here's the fins after a CWF fill and sand with 400 grit.
Filler/primer spray follows then more sanding to surface with 400 grit.
The fin gluing line had the filler/primer scraped off.
Filler/primer seals the surface. Wood glues won't stick as well on a sealed surface.
After scraping, redraw the root edge pencil lines.
No comments:
Post a Comment