Here's the balsa plug fill on the upper end of the N piece.
Two fill pieces go into the L and M wing pieces.
After the glue dries, the raised fills are sanded to surface using 400 grit on a sanding block.
The T piece tab is a bit short. It'll also get a balsa fill segment.
The inset shows the tab before and after lowering the height of the tabs.
Like on the wing, this allows for a thicker plug piece.
The T piece is fitted after the wing is glued on.
For now, glue only the filler segment.
With the T piece all the way in the slot, press in the filler piece until it butts up against the T piece tab inside.
Remove the T piece without gluing it in leaving the plug in place..
No comments:
Post a Comment