Enerjet by Aerotech Strong Arm Build, Part 23, Final Stickers

I'm building three of the Strong Arm kits for Aerotech and I wanted consistency in the models.

I made a template out of cardstock.

Trace around one of the fins.

Set the sticker on the cardstock setting it on a good placement.

Draw around the sticker border and cut out the square.

This is another wet sticker placement.

Set the sticker on the fin, lay the template over the fin and check the sticker placement.

Lift and replace until it is centered in the cut out "window".

These dots or screw stickers were included but there is no reference of the placement. I decided to leave them off the rocket.

Placing the stickers takes time!

I counted 66 stickers on each model!