Estes Semi-Scale Saturn V, Kit #K-39, Part 31, Loose Ends & Edges

The original kit screw was small and tarnished with age.

I switched out a new, larger one.

The instructions have you glue the long launch lug 1/4" to the right of the lower white/black mask below. 

There is a problem - 

At 1/4" spacing, it puts the lug over the side of the fin fairing.

Look close at the left side picture, you'll see two pencil lines. I glued the lug at the 3/16" spacing. 

I scraped paint away down the lug glue line. I didn't apply a glue fillet down the sides of the lug.

Here you can see the lug clearance. If it were set at 1/4" the launch rod would be rubbing against the conical fairing.

You also must clear the feed line and ullage motor tunnels above.