Quest Harpoon AGM Build, Part 6, More Decals

Here's the upper body - check the face card for placement.

Again - notice the wraps all start and finish in a line, one the back launch lug side of the rocket.

I don't normally put the company name on a model.

This one is being built for Quest.

On the left is one of the decal strip overhangs.

Let it dry before trimming. With the decal dry you'll get a cleaner cut.

Use a new single edge razor blade. Use small circular sawing movements being careful not to cut into the fin or the white paint.

On the right is the decal edge after trimming.

These decals were a bit brittle.

I don't normally use Future clear coats, but I did apply some on some decal edges using a Q-Tip.