Sunday, November 22, 2026

Semroc/Estes Mars Lander Build, Part 4, Landing Gear Housings




It was a little confusing, which edge glues to the cardstock housing cover.
I filled and sanded the visible outside balsa faces with CWF,

The inside surfaces were marked with light pencil X's.







The flat face of my sanding block helps get the edges flush.

Looking from the "inside", the side pieces are set to the outside edges of the cardstock cover.






A sharpened dowel tool helped press and round the top of the housing slot.

A second coat of CWF was brushed into the joint seams.






After sanding, the housings got a shot of filler/primer and sanding. 

This might seem like over building, but this design has many detailed surfaces. Filling and sealing now will save sanding time later on.

No comments:

Post a Comment