Estes Leo Space Train #7285 Build, Part 3, Wing Joint Supports

Look to the inside corner of the wing and stabilizer joint to see Part N, the wing reinforcement piece.







You'll need to shape these two pieces.

Here's a closeup of the inside wing joint part right off the laser cut balsa sheet.

The sides are sanded down at a 45 degree angle on both sides.
On the right the piece is upside down. The upper corner will tuck and glue into the inside wing/stabilizer joint.

Here's the same piece turned over.

The top ends are then tapered. Check the face card picture for clarification.