Centuri Skylab Build, #KB-4, Part 24, Decals!

I drew up the decals from the scans at Jim Zs. These were sized for the slightly larger diameter Centuri ST-7 tubes.

Shown on the left - 

The second lined wrap decal was cut a bit shorter to fit the BT-20 tube.

When cutting a decal like this,

Round out the clear areas instead of cutting into the corners.

A sharp inside corner could end up tearing.


 

This louvered hatch decal goes over the nose cone.

The 3D print has a raised line.

Smooth and work the decal into the ridge with a wet Q-tip.

Here's the finished nose cone.

Those small camera focus targets are always difficult to set on straight.