New decals were drawn up in Corel Draw.
I probably could have used the decal scan from Jim Z's but I like a challenge. It also looked like the Centuri kit decals were on a sheet taller than 11". Home print decals are a standard 8 1/2" x 11" size.
The original kit had some sort of embossed thermal foil used in attic insulation.
I did a post about it in February of 2020: CLICK HERE
This time around:
The second decal grid sheet on the right side shows my attempt at the solar panel fin coverings.
The 3" x 3" square fins will get a chrome Monokote skin followed by the blue grid water slide decal. Results were very good the first time this technique was tried: CLICK HERE
In the lower right of the solar panel decals are the fine ink lines used to finish the Mini Bomarc.
No comments:
Post a Comment