Estes USS Enterprise #1275, Part 21, Intercooler Prep

Note - The front side of the cardstock intercooler piece is shorter than the rear.

The die cutting process has buckled the the centers of the intercooler pieces.

I filled the depressions with CWF and sanding. Here the pieces are taped down for a shot of filler/primer.

After sanding the filler primer.

In this picture, the front is to the left side.

There are small die-cut inconsistencies in the length of the inside cuts. All four dowels were cut to fit each individual intercooler piece.

The pairs were pencil marked 1, 2 3 & 4.

The dowels also got a shot of filler/primer and sanding.

Note the tall overhang of the front end cardstock.

This was trimmed down to fit the diameter height of the dowel.