Over time, the built-up card stock end of the connector could unwrap.
I also wanted to round over the square end.
Some medium CA was applied and the edge rounded with 220 grit.
Inside the connector, here's how the shock cord was tied on.
The cord went over the "X" struts.
A Duncan Uni-Knot was used.
The top side of the connector was too tight going into the upper tube section.
These edges were also rounded for an easier slip fit.
On the other hand -
The nose cone cone was very loose!
A single wrap card stock was glued into the body tube.
I could have used wraps of masking tape on the nose cone shoulder.
On a larger body tube I'd rather build up the inside of the tube.
No comments:
Post a Comment