ASP Micro Hawk Build, Part 1, Parts

After building the BIG TLP Hawk, how about  small one - 

I still have to paint and draw up decals for the bigger Hawk.

This one I will finish and apply decal.

Enlarge this picture to see the specs - It's only  4.15" tall!

There are three full pages of instructions, printed on both sides.

From the left going clockwise to the center - 

1" x 8" orange Mylar streamer, Kevlar line, 3D printed nose cone, Styrene angle,

Fin and Tunnel material, water slide decals, two 1 1/2" long brown couplers, nose weights, two main body tubes.

Parts of interest:

The nose cone is very smooth for a 3D printed part.

Two US ARMY water slide decals

Three split lead weights

Plastic launch lug and placement spacer