Tuesday, June 4, 2013
Big Girtha Rebuild Part 9 Engine Mount
Cut out the circles as best you can with a sharp knife.
You can sand to the edges of the inside engine blocks using 220 grit on a dowel or back end of a Sharpie.
Here's the finished mount - no chance of the ejection charge blowing out the back.
The two engine mount tubes fit close to the inside walls of the Quest 40mm tubing. Ideally you should have a second lower centering ring but the fit is close enough it might not be needed.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment