Custom PONG Finished

This was the toughest 13mm build I've ever done!
Like the face card says it is "Super Detailed!"
If you are looking for a smaller challenge, this is the kit.

Tall for a BT-5 model, it stands 19 1/2" tall.
While I don't like stick on decals these do add a lot to the looks of the model.
Just remember, when you set one down you can't reposition it!

TIP: There is no engine hook, you are told to friction fit the engine.
I don't like friction fitting engines, especially on a thin walled BT-5 tube.

The engine mount tube and engine both extend beyond the end of the body.
A simple wrap of masking tape will hold the engine in place throughout the entire flight. Remember earlier how the extended tube got a coat of CA glue to keep it from peeling? This is why.
When the tape is pulled off there is less chance of the tube delaminating.
Be sure to press the tape down before launching.

EDIT: This model is on display at the model rocket exhibit at the Seattle Museum of Flight.