Mark the depth for the glue bead. Apply a drop of glue and rotate the stick end in the body tube.
It'll probably take a few applications to get a line of glue all the way around the inside.
The supplied yellow tube is used to push the engine block in.
For strength, both ends of the tube got a wipe of CA glue using a Q-tip.
After it dried, the glue was smoothed with some 400 grit.
The Kevlar is tied to the elastic like in the old Quest kits with a simple overhand knot.
The loose ends were cut together clean with a wire cutter.
No comments:
Post a Comment