Quest Viper Build Part 6, Trim Tape and Finished!

I decided to use the name sticker.
Trim it evenly just outside the printed area.

I used small pencil ticks for centering. You should have reference marks, once you set these stickers down, they are stuck!

With the red on the name sticker, the model needed some more red trim.

A long triangle strip was cut and set on one side of all four fins.
These were cut a little long and trimmed off with a razor blade.

I used the red bars behind the Viper name sticker for the widths of the forward trim stripes. Pencil ticks were drawn and these were transferred to the Monokote red trim sheet.

Here's the model before:

And after the red trim was added.
I should have spread out the forward red stripes like the rear spacing behind the Viper name.
Oh well - FINISHED!