Wednesday, July 17, 2013
Rocketarium Hydra Sandhawk Build Part 3, Sustainer Engine Mount
While the kit has a tri-fold mount, I'm switching out to Kevlar.
A small notch was filed in the upper centering ring for the line to pass through.
The forward ring is flush with the end of the body tube.
A ring of glue was applied and the ring pressed in place using my flat sanding block to insure it was flat and even.
A few of the tube cuts were a little rough.
Check all the tube ends and sand flat with your block if needed.
Here's the finished sustainer mount with the Kevlar line in place.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment