Thursday, July 4, 2013

Sirius Interrogator Build Part 4, Tube End Seam Filling


I applied some medium CA on the tube edges with a Qtip. I only apply the CA to about 3/16" inside the open end.
Fine sanding got the edge to a hard smooth cut.

On the upper right, the edges of the BT-5 ramjet tubes were sanded smooth with sandpaper wrapped around a pen barrel.


The angle cut BT-55 intake tube and BT-5s had interior seams that might be visible when the model is assembled.

CWF was applied and sanded smooth.

No comments:

Post a Comment