Estes Honest John, #7240 Build, Part 12, Gluing The Band Wrap

A wrap of copy paper was taped around the body tube for a base line.
The top of the paper strip is 4 3/8" from the bottom of the tube.
Setting the punched band on the top of the paper strip will center the wrap.
The bottom edge of the wrap will end up 4 3/8" from the bottom of the body tube, not the fin unit.

The wrap band (I made two) was taped down to a piece of card board. It was lightly sprayed with 3M adhesive.
The instructions show white glue being used but the glue might pool up on the punched holes.
Go light on the adhesive, it's easy to spray on too much.

Here's the band in place.
The inset picture shows the kit supplied wrap with the laser cut notches. On the wrap I made the holes are cleaner.
The home wrap holes might not be perfectly in line but sometimes kit upgrades are a compromise.