Vulcan Fin Tip Reinforcements Part 2



 Slide the angle cut toothpick down into the outside crease of the air scoop.

Keep sliding down until the angle cut of the toothpick is even with the angled top of the air scoop fin tip.

While the card stock fin is wet with glue, you can press and reshape some of the creases. Roll a dowel over the card stock against the dowel inside the air scoop.





When the glue is dry, you can trim off any excess toothpick with a very sharp knife.







Here's the finished reinforcement toothpick glued and trimmed inside the crease of the air scoop.