The upper half of the adapter has a recess area with two large bolts.
To get an approximate size of the area, I took a picture of the Alway drawing.
This picture was set into Corel Draw and reduced until the lower tube width was 35 mm., the same diameter of the lower tube on the model.
From this reduction I could draw a simulated recess, shown to the right of the Alway drawing.
The screw and adapter decals were set on a master sheet for printing on a half sheeet of decal paper.
Patreon members: If you'd like a copy of this drawing in a PDF format, send a request for the Nike Tomahawk decal to:
oddlrockets@bellsouth.net
After looking at the first print, I went back and made the screws smaller. The picture to the left shows the larger screw heads.
I make no claim that these screws and decals are true scale. At best, they are "close". The model is a semi scale build anyway!
No comments:
Post a Comment