Estes Interceptor Build #1250, Part 6, Wood and Tube Seam Filling

Thinned CWF was brushed over the fins before gluing onto the body tube.

Look close, the wood grain is raised. This might lead to additional filling later on.





Here's a good example of the inside corner on the two piece fins.

After the sanding block rounded the leading edge, some clean up was done with some smaller pieces of 400 grit

The crimped tube area got a coat of CWF and fine sanding.

After the area was sanded flat some medium CWF was brushed on with a Q-tip. This was smooth sanded again with 400 grit.