This is not a necessary step, but you know me!
I had to decide which would look better, rough glue fillets on the joints or a smoother surface transition.
Some thinned CWF was dragged down the joint similar to how I'd normally fill the body tube seams.
On the left is the CWF after sanding with 400 grit.
On the right I've dabbed on some filler primer with a Q-tip for a final fill.
Here's the upper stage fins, antennas and filler smoothed.
All eight fins are ready for gluing on the upper body in the next post.
No comments:
Post a Comment