The lander legs are glued on the body tube, then the triangular pieces are glue around the upper leg.
I thought the leg supports would be easier to smooth out off the model, especially the joint seams at the open slot top.
Glue the small center piece on one side of the larger side supports. Follow with the side support on the other side.
The tops and bottoms were sanded smooth on some 400 grit.
Here's a dry test fit of a lander leg in the support housing.
With the new, even sanded tops on the support housings I had to give them another shot of filler/primer and smooth sanding.
No comments:
Post a Comment