Building The Card Stock Downscale Centuri Hornet Part 7, Lug cover

This model uses a 1.25" long LL-2A launch lug.
Cut out the yellow square from the 24 lb. printed page.

Again use the glue stick.
Try for an even coverage all the way to the edges.

On the lug wrap start from the center and roll on to the outside edges.

The inset picture shows the covered lug and seam side.
The seam side will be glued down on the body tube lug line.

The wrap is oversize.
After the glue dries, sand off the overhanging paper.