Estes Gyroc Build Part 2, Cutting the Parts

The Fins (2) Flaps (2) and Rudders (4) were cut from 1/16" balsa stock.
This was old school, tracing around the templates on the balsa with a pencil.

All were cut out with a sharp blade and straight edge.
Because these were hand cut, like fins were gang sanded with a block.

The hardwood tabs (called "Flap Holders" on the pattern sheet) were carved from a larger craft stick.

Pencil lines were extended outside the pattern.
Cut the stick width first.

Next, round the ends.
Cut the tabs to size last.