Monday, May 11, 2015

StratoFins Water Rocket, Launcher Assembly Part 3



The low ends of the cable ties and tape are cut off 3 3/4" down from the top. The instructions say to use scissors, I used a sharp blade and straightedge.

The tape and ties were scored and cracked in half down the cut line.



Wrap the assembly around the vertical tube with the bulge on the low end. I used a small piece of tape to hold the ties closed.

Center the hose clamp on the tape and tighten the screw.





You assemble the fins onto the nozzle.
Notice how the fins are locked onto the center nozzle by the bottle lip.





The bottle is slid down until the ties just latch onto the bottom lip of the StratoFins nozzle.

No comments:

Post a Comment