Sunday, March 27, 2016

Madcow Bomarc Build, Part 8, Conduit and Nose Cone Work

Here's the front and back end views with the conduit glued on.
In the upper picture there is a slight gap on the conduit sides. This will take a few fillets of Titebond M&TG.
The rear picture shows the tapered conduit fit around the base of the rudder.
Now the model is looking like the Bomarc.

The nose cone has to be opened up for the nose weight.
Cut an opening on the opposite side of the shock cord tie.
The plastic was easily cut with a hobby knife.

No comments:

Post a Comment