Cut through the hold down tabs and remove the dots and rectangles.
TIP: Sometimes you can remove some laser cut discoloration with an eraser.
On the left, I'm sanding some of the laser burn off the fin edges.
Some probably might think I go overboard trimming and smoothing things out. I actually enjoy working on the small details.
A small diamond file took down the tabs.
With a twist of a (rough) sharpened dowel, any remaining tab was compressed and the hole rounded out.
Use a white eraser. A pink eraser might leave some pink color.
On the left, I'm sanding some of the laser burn off the fin edges.
On the right - Leave the rectangular hold down tabs. The tabs give a tighter friction fit against the fin tabs.
No comments:
Post a Comment