Saturday, January 9, 2021

Semroc Laser X, KV-33 Build, Part 2, Adapter Assemblies


You make two adapter assemblies, one for the engine mount, the other for the mid body adapter.

The centering ring with the two holes is used in the upper adapter. A Kevlar loop is tied through the two holes. Some Centuri kits used a shroud line to tie the model together instead of a screw eye in a balsa adapter.


TIP: The coupler ends can be sanded for a flatter gluing edge.

Tubes and coupler ends are usually cut at a slight angle. 




The centering rings are glued onto the coupler ends.
Lay the glue bead with a bit more on the inside edge. Set the ring on and twist it, making a more even inside fillet. 


You can smooth the interior fillet and remove excess glue using a Q-tip. 









The Kevlar in this kit was braided. To prevent fraying you can rub some white or wood glue on the ends. 
TIPS: Never use CA (super glues) on string, cords or knots. CA glue will make the line hard, brittle and easy to break.
The instruction illustration shows a bigger loop than is necessary.

No comments:

Post a Comment