Wednesday, August 2, 2017

Estes Nemesis #2175 Build, Part 10, Stickers

I did use the "Go Wild" stickers.
The pre-cut stickers didn't match the leading edges of the fins.
I did my best to get them centered. The underside shows the overhang.

Before laying down any stickers or water slide decals, be sure the surface is flat and clean.


The overhang was trimmed off with a sharp knife. Be careful not to cut into the balsa fin.







The Nemesis sticker on the rudder needed to be cut close of the name would overhang the leading edge.

No comments:

Post a Comment