After all four long stripes were set down, the stop wrap of paper is removed.
You can see how well the square tops have lined up.
Cut the overhanging ends off the back. Don't cut them close, you'll trim them with a sanding block later.
Keep these, they are used for the smaller checkerboard pieces. They should be close to the correct width needed.
Set them back on the backing sheet and cut them into perfect rectangles about 5/8" high.
Set these smaller rectangles down between the top of the long stripes.
I had two that were too wide. Set them down, mark with a pencil. Trim and re-apply.
No comments:
Post a Comment