Quest Raptor Build Part 20 Nose Cone Canopy Decal

All the decals had a clear overcoat except for the canopy decal. When put in the water, this decal would separate into eight separate pieces!

I thought the decal was too large anyway so I cut out a new one from my roll of Contact Paper Blackboard material.

My canopy was a little smaller with simpler cuts.

To be sure it was centered when sticking down the eight pieces a strip was stuck down the center from the nose cone tip to the shoulder.

All the pieces were set down on either side.

Here's the finished canopy.
This is easier to do than you might think.
I was happy with the results.