I didn't cut out the "lower decal" template.
I extended the outside borders with pencil lines and used as a guide to cut the vinyl squares. The template and black vinyl were both taped down for cutting.
Set the first piece down below the launch lug.
Set the vinyl square down with your knife blade.
One side was set down into the root edge.
All four of my cut rectangles were a little wide.
I cut the excess width off using a straightedge and sharp knife.
Cut just the vinyl and not into the paint in the root edge.
Lay down both lower rectangles, the second one opposite the launch lug side.
Set the two upper rectangles in line with the lower two.
The picture at the right shows the excess trim edge being lifted.
No comments:
Post a Comment