Saturday, February 7, 2015

TLP Pershing #K046 Build, Part 29, New Fin Vane Pads



I used the 2" machine square to mark the fin pads for sanding.

The machine square has been indispensable in my model building for marking and checking 90 degree angles.
To get the curve at the top of the pad, 220 grit sandpaper was wrapped around a BT-60 tube.
The vane was held at a 90 degree angle and the top curve sanded.







Three of the six vane pads.
The rear pads are a little longer than the upper second stage pads.

No comments:

Post a Comment