The wing is glued onto the glider BT-20 tube.
TIP: Don't even try to make a glue fillet in the tight wing joint. It would take too many bubbled glue fills adding weight to the glider.
I did add a fillet to the front and rear of the wing - not down the sides.
The glue side of the elevon was also sanded at an angle for a better joint. This make for a better fit and a stronger model.
The original kit guide was used to set the elevon angle.
The glider nozzle was made a double layer nesting "super shroud" for strength.
Here I'm cutting off the overlap of the inside shroud.
Here's the thicker nozzle glued onto the laminated rear disk.
No comments:
Post a Comment