Sunday, December 2, 2012

Dr. Zooch Saturn V Build Step 10B Part 2 Spoofs





Roll the spoof in place making sure the top edge is even with the top of the dowel end.








The top of the spoof wrap should be even with the top of the upper shroud cone.

I had to trim off quite a bit to get the two ends even.



When the F.G.P. was totally dry, the indent dowel hole shrunk up a bit.
In the picture, the once round indent circle has a flat side against the upper shroud.

To get a slip fit, the side of the dowel had to be sanded down a bit.





Here’s the finished nozzle and heat exchanger assembly.

No comments:

Post a Comment