Saturday, December 8, 2012

FlisKits Triple Threat Build Part 8 Persephone Upper Shroud


This is a dry fit of the smaller, upper shroud on the Persephone Saucer.
This shroud tapers in. It's formed "inside out" with the printing on the inside.
The only glue is on the root edges of the fins so there were narrow open gaps between the three fin glue contact points.





I cut small glue tabs from 65 lb. card stock.
These were scored at the mid-point "hinge" bends before they were cut out.

The tabs were glued and set in place with tweezers.

No comments:

Post a Comment