Estes Plasma Probe Build Part 4 Kevlar Tie

Sometimes the Kevlar doesn't want to sit flat against the forward ring.
Setting the Kevlar into the fillet - 
The loop was tightly tied around the motor mount tube and the loop slid back toward the rear.

A fillet was applied to the ring and smoothed out with a fingertip.



Allow the glue to set up, but not fully dried.
The glue is tackier now and will hold the Kevlar tight against the back of the centering ring.

Press the Kevlar into the glue. With the glue "half dried" the loop will hold tight against the underside of the ring.