Monday, June 23, 2014
Quest Aurora Build, Part 8, Glider Cradle and Rudder Gluing
The inside edges of the wing were sanded for a better match for the dihedral angle.
Like the instructions showed, the glider body was used to help set the angle. The tip was raised 1 3/8" from the table surface.
One of the 2" lugs was glued on where the fin was removed earlier.
Plastic cement wouldn't hold it on so I used some medium CA.
One cradle plate piece is glued on each side of the launch lug.
At the open top the spread space is 7/16"
The tube is glued down the center joint of the glider wings.
The inset shows a small rudder in position.
The bottom of the wing joint is sanded flat for gluing the root edge of the large rudder.
Labels:
Build,
Fin Alignment,
Launch Lug,
OOP,
Q Aurora,
Quest
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment