Friday, October 30, 2015
Estes QCC Explorer Build Part 17, Gluing On The Intakes
I made a four fin marking guide and used the fin lines to line up the left side of the intakes.
The entire intake sides were traced with a pencil.
Inside the pencil lines, the primer was scraped off down to the tube.
The first two intakes were glued on opposite sides and spaced visually from the rear.
A piece of paper was marked and used to guarantee the space between the intakes was consistent.
The flat side of a sanding block was set against the tube end to be sure the rear of the intakes were even with the bottom of the body tube.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment