If you haven't scored the canopy, do so before trying to glue it together.
A slip of paper was slid under the glue tab to keep the glue stick off the printed right side.
Long tweezers were used to hod the tab down while the glue set up.
It's easier to glue on the interior launch lug fin supports with a guideline. Hold a wing or rudder up to a bright light and make some pencil marks at the center of the black line.
Glue a 1 3/4" launch lug on the line centered between the two side edges of the wing.
Fold over the fin and glue the other side to the lug.
Here's the finished wing.
The bottom tabs are folded out to be glued to the body shroud.
No comments:
Post a Comment