Estes Asteroid Hunter #3224, Build, Part 9, Body Skin Alignment

I used one side of my architectural ruler to "set" the emboss line and make a sharper crease. 

Set the line you have already embossed over the edge of the ruler and run a smooth burnisher down the crease. 

Here's one side of the skin after "setting" the fold.

Do a few dry fits before using glue to get used to how the skin will set over the structure.

There will be an overhang on all sides.

I decided to set the skin with less overhang on the front. I knew the tighter fit on the smaller front end would be harder to trim.

Looking inside the housing, this is still a dry fit - 

The angled sides of the interior bulwarks are curved. The skins "float" over these curves. On the next post - Do not apply glue on the curved sides. Glue is only applied to the edges of the Y, Z and AA side pieces.