Thursday, October 7, 2010

Wolverine Downscale "How To" Part 7 Nose Cone


After trimming the nose cone down to the ram jet profile, I decided to fill the two pieces separately. The flat top of the lower section would be hard to keep square it it were filled and sanded with the tip glued in place.

Before using Carpenter's Wood Filler, a dot of masking tape was taped to the center of the lower nose cone part. You can see it just to the side of the tip. This would give me a better raw wood gluing area.






Here's what the ram jet cone looked like, a dry fit just prior to filling.

No comments:

Post a Comment