Those small center curves are easier to cut with a large barrel on the rotary punch.
I'm never able to cut anything that round and small with the tip of an X-Acto.
Here's the other tools needed to cut and form the two piece nozzle bells.
The long tweezers is for holding down the glued tab.
The blue en will be used to preform the shrouds on the soft heel of my hand.
Make all your straight cuts with a knife and straight edge.
Make all the curved cuts with sharp scissors.
TIP: You can sharpen scissors by cutting through 400 grit sandpaper.
No comments:
Post a Comment