ASP Corporal Build, Part 10, Fins and Tunnels

With a fin overhanging the tube end by 5/8", a piece of paper was taped around the tube to line up the front ends of the fins.

Beside the root edge of the fin you can see the sanded white gluing area.

All four fins were glued onto the tube and the alignment paper removed.

The tunnels glue directly above the fins.
New lines were extended down the tube and the primer sanded off.

There is a "gotcha" in the instructions. 
The instruction copy says the front of the smaller tunnels are 4 5/8" from the front of the long tube.
The illustration says the front of the tunnel is 7" from the front of the tube.
Looking at the illustration and face card drawing I glued them 4 5/8" from the top of the tube.

Here's how the model looks now with all the fins and tunnels glued on.
It looks larger than it is. The model is BT-50 based and 19" tall.

Painting should be easy, it's all white.