ASP Corporal Build, Part 8, Engine Mount Gluing

It's hard to see in the picture but there was a small crease on one end of the tube.
If I glue a fin over it, it will strengthen the tube and hide the crease.

When marking the fin lines, I purposely set the tube crease on a fin position line.

This is another thin BT-50 tube. To protect it from crimping a 2" long, 50 sized coupler was cut.
A glue line was set up in the tube at about the middle of the coupler final position.
The coupler was pushed into place using the engine mount.

The engine mount was removed.
More glue was spread in the tube and the mount slid in place.

TIP: It's easier to line up the engine hook when a pencil line is drawn down the body tube, this time in line with the lower launch lug.