On the lower wrap is a two piece detail.
The lower piece was a thinned down Popsicle stick. The upper round is a toothpick with the bottom sanded flat.
After gluing the toothpick with CA, the front angle was made with 220 grit on a block.
I matched the angle of the cut against the angle in the wrap picture.
The front was rounded using a sanding block.
The second on the right is ready for rounding.
As before, the longer pieces are shaped then the back end is cut off to the length needed. It's just easier when you have more of the back end to hold onto.
No comments:
Post a Comment