Tuesday, January 15, 2013
Quest Cobalt Build Part 5 Step 10 and 11 Gluing Fins and Lug
The launch lug was glued on and the body tube primed and sanded.
Sometimes its easier to prime the body tube with the fins off.
The fins were primed and sanded before gluing onto the body tube.
Fin lines were marked then those pencil lines were roughed up for better adhesion.
The picture shows the FinTool holding the fins at a 90 degree spacing.
The Cobalt is ready for the first white spray coats.
Subscribe to:
Post Comments (Atom)
No comments:
Post a Comment